|
Single-phase and multiphase models for temperature and relative humidity calculations during forced convection in a rubber-sheet drying chamber |
|---|---|
| รหัสดีโอไอ | |
| Creator | 1. Perapong Tekasakul 2. Racha Dejchanchaiwong 3. Yutthana Tirawanichakul 4. Supawan Tirawanichakul |
| Title | Single-phase and multiphase models for temperature and relative humidity calculations during forced convection in a rubber-sheet drying chamber |
| Publisher | Maejo University |
| Publication Year | 2557 |
| Journal Title | Maejo International Journal of Science and Technology |
| Journal Vol. | 8 |
| Journal No. | 2 |
| Page no. | 207 |
| Keyword | natural rubber,rubber-sheet drying,multiphase model |
| ISSN | 1905-7873 |
| Abstract | Computational fluid dynamics modelling of single-phase and multiphase flows was used to simulate the temperature and relative humidity at various locations in an empty rubber-sheet drying chamber. In all planes, unlike the single-phase model, the multiphase model's temperature distribution is relatively uniform, and the temperature deviations are 0.01-4.73?C in the bottom plane, 0.02-4.05?C in the middle plane, and 0.01-3.84?C in the top plane. The single-phase model results in temperature deviations of 0.55-6.63?C, 0.02-6.02?C and 0.36-3.89?C in the bottom, middle and top planes respectively. Thus, the multiphase model is deemed superior. The inclusion of water vapour in the multiphase model increases the agreement between model and experimental temperature data. The largest temperature deviations occur at the centre-frontal positions of all planes owing to the turbulence of the hot gas at the inlet. In all planes the relative humidity is almost uniform, except near the centre-frontal area of the bottom plane. Clearly, the multiphase model is more appropriate for simulating chambers containing rubber sheets, though the diffusion of moisture from rubber sheets needs to be considered as well. |
